Preheat the oven to 325°F. Place the ham on a rack in a shallow roasting pan. For a whole 10- to 15-pound ham, allow 18 to 20 minutes per pound; for a half–5 to 7 pounds–about 20 minutes per pound; or for a shank or butt portion weighing 3 to 4 pounds, about 35 minutes to the pound.
Do you cook a ham at 325 or 350?
For boneless hams, bake at 325 degrees; for 6- to 8-pound hams, about 20 minutes per pound. For a bone-in ham, cook at 325 degrees; for up to 14 to 16 pounds, about 12 minutes per pound. For canned ham, bake at 325 degrees; cook a 3-pound ham about 21 minutes per pound.
How long does it take to cook a ham at 350 degrees?
Preheat the oven to 350 degrees F. Unwrap the ham and rinse it under cold water. Place it on the rack in the roasting pan. Cover with foil and bake 1 hour 40 minutes.
How long do you cook a ham that is not precooked?
Allow 20 to 30 minutes per pound for ham that has not been precooked (follow directions on label for precooked hams). Begin roasting ham by placing fat side up, the melting fat will baste your ham. Turn ham over half way through baking to avoid uneven salting from the brine in the meat.
How long does it take to cook a ham?
How long does it take to cook a ham? It takes approximately 15 minutes per pound to bake a ham in the oven at 350 degrees F. Be sure to use a thermometer to confirm that your ham is cooked to the proper temperature and is safe to eat.
Do you cover a ham when you bake it?
Cover either the ham itself or the pan with foil. Make sure it is covered well so the ham doesn’t dry out. Set the oven to 350 degrees and bake the ham, basting every 15-20 minutes. Uncover the ham when you baste it, but then cover it back up when you put it back in the oven.
How long do I cook a 12 pound ham?
A 12-pound ham will take about 18 to 20 minutes per pound to bake, or roughly three and one-half to four hours. At the lowest time estimate, begin checking the internal temperature. When it reaches 160 degrees F, the ham is done.
What temperature do you cook ham to?
A fully cooked ham needs to be cooked to 140°F (basically just to heat it) where as a “cook before eating” ham needs to be cooked to 160°F. When cooking ham, you’ll want to preheat your oven and place the ham cut side down. Cover the ham in foil and crimp the foil around your roasting pan (I use a 9×13 pan) to seal it.
What temp does a precooked ham need to be?
Place the ham on a rack in a roasting pan. Add water to the bottom of the pan and cover tightly with lid or foil. Bake at 325 F for 15 to 18 minutes per pound until a meat thermometer registers 140 F.
Is a smoked ham fully cooked?
The answer, in short, is if it is cured, smoked or baked, ham is considered “pre-cooked,” and would not technically need to be cooked. This includes the ham that is purchased at the deli. In fact, most ham that is sold to consumers is already cured, smoked or baked.
How can you tell if ham is cooked?
If you do wish to reheat a cooked ham, bake at 325°F until a food thermometer inserted into the ham reads an internal temperature of 140°F. For raw and fresh ham, bake at 325°F until a food thermometer inserted into the meat reads 145°F.
How long should you cook a smoked ham?
Put the ham, flat-side down, on a rack in a roasting pan. Pour 1/4 inch water into the bottom of the pan. Transfer to the oven and roast until a thermometer inserted into the thickest part of the ham registers 130 degrees F, about 2 hours, 30 minutes (about 15 minutes per pound).
Do you have to heat up a fully cooked ham?
A fully cooked, ready-to-eat ham (also referred to as a “city ham”) can be sliced and served cold or at room temperature—there’s no need to reheat it.
How do I cook a precooked ham?
HOW DO I COOK A PRECOOKED HAM? A precooked ham should be cooked in the oven at 325 degrees F for 10 minutes per pound, or until it reaches 145 degrees F, according to the USDA. If you’re reheating a ham that was repackaged or leftover, it needs to be cooked to 165 degrees F.